PowerSupply DC24V

Power Supply DC24V, ISOLGUARD series is an universal power supply for mounting on the 35mm DIN rail. The product is primarily intended for powering the remote monitoring module MDS-D, MDS-DELTA produced by HAKEL company. Output voltage is stabilized for 24 V DC. The supply voltage can be DC or AC in the ranges which are written below in the specification table.

This power supply source is also designed for industrial use such as current loop power supply of the two-wire transmitters, sensors power supply, indication devices power supply etc. For the safety viewpoints it meets the standard IEC 61010-1:2010 (Safety requirements for electrical equipment for measurement, control, and laboratory use).

Connecting the Power Supply DC24V to the voltage is signalled by a green LED on the top of the product.

Dimension drawing
Dimension drawing
Installation diagram
Installation diagram
PARAMETERS
Supply voltage AC Un AC 90 ÷ 265 V AC (47 ÷ 440 Hz)
Supply voltage DC Un DC 90 ÷ 370 V DC
Output voltage Uo 24 V DC
Maximum output current Imax 110 mA
Power P max. 2,5 VA
Operation signalling green LED
Short-circuit protection Yes, on the output, with an automatic renewal of the power supply after the fault
Thermal fuse Yes, with an automatic renewal of the power supply after the fault
Isolation voltage input / output 4000 V AC
General data
Degree of protection according to IEC 60529 IP20
Weight m 95 g
Method of assembly DIN rail 35 mm
Recommended section of the connected conductors S 1 mm2
Operating conditions
Operating temperature ϑ -10°C ÷ +65°C
Relative humidity 28 g H2O /kg of dry air
Atmospheric pressure 86 ÷ 106 kPa
Operating position any
Overvoltage category / testing voltage III according IEC 60664-1:2007
Pollution degree 2 according IEC 60664-1:2007
Operational mode permanent
Article number 70 062
CERTIFICATIONS
DOWNLOADS
Catalogue
2D model (538.44 KB) for registered only
3D model (351.88 KB) for registered only